Released new Configurator (http://www.tiecar.net/CANtieCAR_Configurator.html) and Firmwares for CANtieCAR v4.x (http://www.tiecar.net/CANtieCAR4_Firmware_RC.html) and CANtieCAR v5.0 (http://www.tiecar.net/CANtieCAR5_Firmware_RC.html) with new Passthru Driver
Full native networking over WiFi (AP and/or STA) is supported!
To install Passthru Driver the new Firmwares are required Latest Configurator (http://www.tiecar.net/CANtieCAR_Configurator.html)
Hi.
what is that for? Can i use passthru over wifi??
Quote from: pardul on March 12, 2024, 23:13:11
Hi.
what is that for? Can i use passthru over wifi??
yes of course
now you can use USB, Bluetooth and WiFi for Passthru - Passthru driver supports all on them
Can you explain how to setup some program to j2534 over wifi? Tried yesterday with odis and forscan but no luck,
passthru driver will find CANtieCAR if Configurator found it once
i am going to create user manual for networking few later
short tips for Configurator
===
Settings Tab - select port, find CANtieCAR, switch modes
Update Tab - reset CANtieCAR or upload firmware
Network Tab - manage network ports
Passthru SAE J2534 Tab - install Passthru driver and check Passthru adapters
About Tab - About...
System Tab - About CANtieCAR, switching default wireless link Bluetooth-WiFi, reset and update WiFi chipset
WiFi Tab - manage configuration of WiFi chipset - SoftAP, Station (connection to router/hotspot) etc.
Test Tab - testing of all CANtieCAR hardware
I done it, works. Thank you. Good job!!
Quote from: pardul on March 13, 2024, 23:20:10
I done it, works. Thank you. Good job!!
it would be great if you share your experience with everyone :-)
It was easy
when ctc was conected to acces point, just must search it in network tab in configurator and then it works