Author Topic: BMW EWS3 resetting to factory default  (Read 34023 times)

g0tcha

  • Newbie
  • *
  • Posts: 8
BMW EWS3 resetting to factory default
« on: September 14, 2007, 12:19:59 »
hi

i have read a EWS3 (0D46J) and i want to put inside my car, i have found some software called ews3 edit and managed to set the EWS3 to factory default. if i put this in my car and sync with bmw scanner etc will itlearn my car info from DME and key automatically.

i just would liek to know what the factory default option can do.

bmwsss

  • Guest
Re: BMW EWS3 resetting to factory default
« Reply #1 on: September 14, 2007, 12:54:28 »
Now you need to make adaptation, either the original scanner, or 136

g0tcha

  • Newbie
  • *
  • Posts: 8
Re: BMW EWS3 resetting to factory default
« Reply #2 on: September 14, 2007, 15:00:07 »
hi

can you tell me which adaption you talking about ? adaption DME -> EWS3 ?

also do i not have to make the DME virgin state also ??

bmwsss

  • Guest
Re: BMW EWS3 resetting to factory default
« Reply #3 on: September 14, 2007, 16:16:08 »
t first you should make ews virgin, and then adaptation

g0tcha

  • Newbie
  • *
  • Posts: 8
Re: BMW EWS3 resetting to factory default
« Reply #4 on: September 14, 2007, 16:20:18 »
well is setting the ews3 to factory default like i did in picture above making it virgin or what ?

if no, how do i make ews3 virgin ?

g0tcha

  • Newbie
  • *
  • Posts: 8
Re: BMW EWS3 resetting to factory default
« Reply #5 on: September 15, 2007, 00:40:18 »
i have done many tests and basically haven't come with positive results.

1)   I reset ews3 to factory default put in car and tried adaption  with bmw scanner 136 and I get the error attached.
2)   I reset ews3 to factory default added correct vin of car in ews3 and then connected to car, and tried adaption and got the error attached
3)   I reset ews3 to factory default added correct vin of car in ews3 added the correct key information of my key0 to fixed key, connected ews3 to car and tried  adaption and got the error attached.
4)   When I use the above scenario’s with key adaption option in INPA I get the message of ecu reject error.

any one know what is this error 153 for

oviko

  • Newbie
  • *
  • Posts: 1
Re: BMW EWS3 resetting to factory default
« Reply #6 on: April 02, 2012, 22:19:08 »
hello everything, I ask if can prompt as me to write down the chip for BMW EWS3 with XPROG M