Products Support > CANtieCAR
Downloads
sleuth:
Mr TizWaz`s Solution on Mhh forum works great with Newest Honda HDS 3.012.030
http://mhhauto.com/Thread-HONDA-HDS-3-012-030-TizWaz-FULL-Build?page=6
It is a full torrent with Video instructions
Regards
miarcin:
You have try it with CanTieCar ??
sleuth:
Yes Sir, Working like a Charm ! Connected to a 2001 CRv I had here.
Also Scanned a 2013 VW GLI from Body shop, Had a host of stored codes , Cleared them all, using the New ODIS and CTC.
Body Shop guys like to store codes in modules it seems. :-)
Unable to get the Subaru working as of yet..or Nissan. But hear Glowing reports about Mercedes DAS and the CTC.
miarcin:
How you get it working, I cannot connect to car, Hoda HDS don's see CTC. Can you describe your way to connection with car ?
sleuth:
PM sent.
I use the spx-mvci changing the device-etc..
Copied from Mhh forum
o.k location to put dealer number is
"HKEY_CURRENT_USER\\Software\\GenRad\\Honda\\Setup\\DealerNumber"=
that is for usa, if you use other region , just use dealer number on install
places to change the interface
"HKEY_CURRENT_USER\\Software\\Teradyne\\Honda\\Setup\\CurrentCommsDevice"="SPX-MVCI"
[HKEY_CURRENT_USER\Software\Teradyne\Honda\Setup]
"CurrentCommsDevice"="SPX-MVCI"
you can test for immofunction and keygen working , if not i post a fix
if you want to install for GNA600 BUT NOT USA
THEN JUST INSTALL HDS For your region and install ECUREWRITE for USA and then just change the country code in regedit
if you are using X-Horse CABLE MINI VCI (MOST ONLY WORKING CAN-BUS) I Think x-horse MVCI(3IN1) IS WORKING O.K, install for GNA600 Also, you need to remove or rename GNAReprogramming.dll < THIS ALSO WILL WORK FOR GNA600'S AND OTHER TOOLS THAT DOES NOT TAKE FIRMWARE UPDATE that use GNA AS A BASE INSTALL
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version