CANtieCAR Wi-Fi Native Support

[Oleksandr]

Released new Configurator and Firmwares for CANtieCAR v4.x and CANtieCAR v5.0 with new Passthru Driver

Full native networking over WiFi (AP and/or STA) is supported!

To install Passthru Driver the new Firmwares are required Latest Configurator

[pardul]

Hi.
what is that for? Can i use passthru over wifi??

[Oleksandr]

Hi.
what is that for? Can i use passthru over wifi??

yes of course
now you can use USB, Bluetooth and WiFi for Passthru - Passthru driver supports all on them

[pardul]

Can you explain how to setup some program to j2534 over wifi? Tried yesterday with odis and forscan but no luck,

[Oleksandr]

passthru driver will find CANtieCAR if Configurator found it once
i am going to create user manual for networking few later

short tips for Configurator
===
Settings Tab - select port, find CANtieCAR, switch modes
Update Tab - reset CANtieCAR or upload firmware
Network Tab - manage network ports
Passthru SAE J2534 Tab - install Passthru driver and check Passthru adapters
About Tab - About...
System Tab - About CANtieCAR, switching default wireless link Bluetooth-WiFi, reset and update WiFi chipset
WiFi Tab - manage configuration of WiFi chipset - SoftAP, Station (connection to router/hotspot) etc.
Test Tab - testing of all CANtieCAR hardware

[pardul]

I done it, works. Thank you. Good job!!

[Oleksandr]

I done it, works. Thank you. Good job!!

it would be great if you share your experience with everyone :-)

[pardul]

It was easy
when ctc was conected to acces point, just must search it in network tab in configurator and then it works

[Oleksandr]

0 - Find CANtieCAR on port with USB connection
1 – Switch Wireless to WiFi on the System tab
2 – Configure WiFi on the WiFi tab
3 – Power the adapter only via the OBDII connector
4 – Connect to the CANtieCAR WiFi access point, if you have not registered the WiFi Station connection of CANtieCAR to your router, etc.
5 – Find CANtieCAR on the Network tab or add it manually, save the changes – this network port will be available on the Settings tab
6 – Find CANtieCAR on the network port on the Settings tab
7 – The Passthru driver will search for CANtieCAR on the network as well... (in general, the search is carried out on all the last 10 ports where the configurator found CANtieCAR)